Remote Control 1 Channel With Antenna

৳ 450.00

Remote Control 1 Channel With Antenna

Out of stock

Text Me When Product Available

Compare

Description

Wireless Remote Control

Material: ABS Plastic

Battery:23A Battery (not included)

Operating voltage: 12V

Frequency: 433MHZ

Current job: 9 ~ 12mA

Transmitting power: 10-15mw

Frequency deviation: ± 0.2MHz

Size (approx.): 58x38x15 (mm) (LxWxH)

Suitable for all lights.

Easy to install and simple to use.

Energy-saving and environment protection

Fast response and long control distance.

Application: Garage Door, Household Electrical Appliances, RGB lights

Stable performance and strong to resist interference, not obstructed by walls and furniture!

Reference distance: 150 meters (This is the theory distance in open environment without interference, practical application due to the interference environment and decreased)

Characteristic: Double control(wall switch function and control function),safety(the shell applies to the fire-retardant material),easy installation(just wire connection)

1 Channel Wireless Relay Switch

Channel: 1CH

Output Current: 10A

Input Voltage: DC10-14V

Working Voltage: DC12V

Standby Current: <5MA

RF Frequency: 433MHZ

Receiver Sensitivity: >90dBm

Dimension (approx.):3.5*3*1.6cm

RF Working mode: Super heterodyne receiver

Remote Control Distance: >100 meter(In open environment)

Decoding Way: MCU Software decoding

Can store the number of remote control:50

Support remote control type: Fixed code, learning code

Wiring Method: Fixed wiring terminal

Rated load:10A 250VAC / 10A 125VAC, 10A 30VDC / 10A 28VDC

Output: Normally open, Common, Normally closed

Multiple working modes: (Jog/Non-Latched ,inter-lock/Latched ,self-lock /Self-Latched)

Working/output way:

Jog/Non-Latched: Press one button is Working /ON. Loosen your finger on the same button is Stop/OFF. One channel switch need one buttons remote control.

Self -lock/Self-Latched: Press one button for one time is working/ON. Press the same button again is stop/OFF. One channel switch need one buttons remote control.

Inter-lock /Latched: Press one button is working/ON, press another button is stop/OFF. One channel switch need 2 buttons remote control.

Delay: Press remote control relay pull-in, release the remote control and begin timekeeping, after 5s,10s,15s will automatically close the relay

You may also like…